How To Cut A Straight Edge On A Table Saw

Cutting a straight edge on a table saw is a pretty standard method in woodworking. This means that you are cutting a rip along with the board at an angle to its edges rather than cutting it parallel to them.

Sometimes you will have to cut a straight edge when you make slender legs from top to bottom, like an angled back slat or a shaker end table. So, you have to use a jig to slice a taper properly on the table saw because you are keeping it at an angle to the blade.

Before you can make anything, you need to straighten the edges. For this, a table saw is required. In this article, I’m going to show you how you how to cut a straight edge on a table saw.

Cutting A Straight Edge On A Table Saw

Many woodworkers use tapering that looks like two arms hinged at one end to adjust the angle of the taper and lock it in. There might be some limitations to this.

One, the workplace might be pretty narrow, and you might find it challenging to hold it against the jig while you are pushing through without getting your hand or the push stick too close to the blade. This can be quite dangerous or inconvenient.

For example, if you imagine your thumb acting as a force on the spinning blade that pushes back against the workpiece as you cut it, the jig will pull away from the rip fence, which can result in a kickback situation.

However, there are safer and better options to cut a straight edge, so you don’t need to worry. The safer method functions quite differently from the old hinge style jig.

Placing The Timber

Here the bar underneath will ride the saw’s slot miter, so the jig doesn’t have to rely at all on the rip fence. It always remains parallel to the blade via the cut with the workpiece resting on the jig base rather than directly on the table saw.

Using A Flexible Fence

A flexible fence will support the wood from behind, and its two-metal hold will lock it securely in place. Fixing up this jig will make a straight edge cut simple.

Start By Cutting At An Angle

You can start by marking the workpiece at the angle you want to cut and then wrap the layout lines around the end and edge.

Adjust The Layouts

Next, keep the workpiece on the jig’s base and adjust the layout so that the marks align with the edge that is closest to the saw blade. Properly slide the adjustable jig fence against and over it and tighten the fences to the star knobs.

Keep It Flush Against The Fence

Lastly, make sure that the workpiece’s backend is flush against the metal stop of the fence.

Final Words

And that’s all there is to it when it comes with making a straight rip cut. Hopefully, now you know how to cut a straight edge on a table saw.

Leave a Comment